ASTM C773 PDF

Purchase your copy of ASTM C – 88() as a PDF download or hard copy directly from the official BSI Shop. All BSI British Standards. Designation: C − 88 (Reapproved ) Standard Test Method for For referenced ASTM standards, visit the ASTM website, , or. Find the most up-to-date version of ASTM C at Engineering

Author: Zuzahn Kagalrajas
Country: Angola
Language: English (Spanish)
Genre: Spiritual
Published (Last): 9 September 2006
Pages: 76
PDF File Size: 16.6 Mb
ePub File Size: 8.51 Mb
ISBN: 372-7-97660-151-8
Downloads: 31136
Price: Free* [*Free Regsitration Required]
Uploader: JoJogis

They may be formed and matured for the purpose of compression testing, or they may be cut from matured whitew- are by sawing or coredrilling. Place an appropriate guard around the specimen to contain flying fragments at failure; eye protection should be used by the operator.

ASTM C 773 – 88

C — 88 Reapproved Standard Test Method for Compressive Crushing Strength of Fired Whiteware Materials1 This standard is issued under the fixed designation C ; the number immediately following the designation indicates the year of v773 adoption or, in the case of revision, the year of last revision.

  BERULUB FR 16 PDF

NOTE 1—It is desirable to include details of the origin of the specimen and subsequent treatment. These faces shall be perpendicular.

Ideally, ceramics should be stressed this way in use. This test is a measure of the potential load-bearing usefulness of a ceramic.

ASTM C773 – 88(2016)

It is the responsibility of the user of this standard to establish appro- priate safety and health practices and determine the applica- bility of regulatory limitations prior to use. Suitable materials for cushion pads, selected in accordance with the compressive strength range of the material being tested, are shown in the following table: New cushion pads shall be used for each specimen.

The spherical surfaces shall be well lubricated, and the center of curvature shall lie on ashm lower face of the platen. The ends of all specimens shall be ground or lapped to yield plane and parallel faces.

Enviado por Thamyres flag Denunciar. Single-operator component Between-laboratory component 1. A superscript epsilon e indicates an editorial change since the last revision or reapproval.

  BTA10 600B PDF

One operator in each laboratory tested ten specimens of each material. If the contact block is cracked during testing, it shall be replaced.

ASTM International – Laboratory Directory – University of Dayton Research Institute

Originally published as C — 74 to replace C and C Precision and Bias 8. The compo- nents of variance for compressive strength results expressed as coefficients of variation were calculated as follows: A number in parentheses indicates the year of last reapproval.

Last previous edition C — 88 Significance and Use 3. Current edition approved Sept. C 5 compressive strength of the specimen, psi or MPa; P 5 total load on the specimen at failure, lbf or N; and A 5 calculated area of asm bearing surface of the specimen, in. Discard any pieces exhibiting cracks or flaws visible to the unaided eye.